Magnavox LCD 19MF330B Owner's Manual

Also see for 19MF330B -: Owner's manual Owner's manual Owner's manual Owner's manual

Magnavox LCD 19MF330B Owner's Manual Manual pdf 6 page image

6ENAttaching the BaseYou must attach the base to the unit to have it as a table topunit. Be sure the front and rear of the base match the properdirection.1 Spread a thick and softcloth over a table asshown.Place the main unit facedown onto it. Make surenot to damage the screen.Insert 2 hooks under thebottom of the main unitinto base holes. (shown byarrow ➀), then move thebase in the direction asshown by arrow ➁ until itstops and the 3 mountingholes are aligned. Makesure not to put the ACpower cord between thebase and the unit.➁➀3 Drive Phillips pan screwsinto the 3 threaded holesat the bottom of the baseuntil they are tight.To remove the base from this unit• Unscrew the Phillips pan screws on step 3.After the screws are removed, move the base in the opposite direction asshown by arrow ➁ on step 2, then pull the base up toward the rear of therunit. Be careful not to drop the base when you remove it.Note• When attaching the base, ensure that all screws are tightly fastened. If thebase is not properly attached, it could cause the unit to fall, resulting ininjuries as well as damage to the unit.• Make sure to use a table which can support the weight of this unit and islarger than this unit.• Make sure the table is in a stable location.• When attaching the base, ensure that FRONT ↑ written on the base isupward. If it's not upward, the 2 hooks don't fit in the base.Fixing the Unit on Your FurnitureScrew this unit on your furniture tightly using wood screws(not supplied) in the 2 holes at the back of the base as shown.• Recommended screw dimension : 5.1 x 20 mmrear of this unitNote• When you remove this unit make sure to unscrew the wood screws fromyour Wood Stand, Furniture and other wood item.Supplied AccessoriesOwner’s manual(1EMN26263)Quick Start(1EMN26264)Remote control(NF804UD)Batteries(AAA, 1.5V x 2)AAAAAAScrew kitfor attaching the base(1ESA19876)• If you need to replace these accessories, please referto the part No. with the illustrations and call our tollfree customer support line found on the cover of thismanual.Note• If you lose the screws, please purchase M4×12 Phillips head screws at yourlocal store.Symbols Used in this ManualThe following is the description for the symbols used inthis manual. Description refers to:ATSC : Digital TV operationNTSC : Analog / Cable TV operation• If neither symbol appears, the operation is applicable toboth.