Makita 1806B Instruction Manual

Also see for 1806B: Instruction manual Parts Breakdown Instruction manual Instruction manual Instruction manual

Contents

7Connecting a vacuum cleaner12004888For European countries and areasWhen you wish to perform clean planing operation,connect a Makita vacuum cleaner to your tool. Install thenozzle on the tool using the screws. Then connect a hoseof the vacuum cleaner to the nozzle as shown in thefigures.For other countries and areasA nozzle and joint (optional accessories) are necessaryto connect a Makita vacuum cleaner to your tool. Consulta Makita catalogue or representative on the nozzle andjoint.12004893OPERATIONPlaning operation1 2002578First, rest the tool front base flat upon the workpiecesurface without the blades making any contact. Switchon and wait until the blades attain full speed. Then movethe tool gently forward. Apply pressure on the front of toolat the start of planing, and at the back at the end ofplaning. Planing will be easier if you incline the workpiecein stationary fashion, so that you can plane somewhatdownhill.The speed and depth of cut determine the kind of finish.The power planer keeps cutting at a speed that will notresult in jamming by chips. For rough cutting, the depth ofcut can be increased, while for a good finish you shouldreduce the depth of cut and advance the tool moreslowly.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol or thelike. Discoloration, deformation or cracks mayresult.Sharpening the planer bladesAlways keep your blades sharp for the best performancepossible. Use the sharpening holder to remove nicks andproduce a fine edge.1002591First, loosen the two wing nuts on the holder and insertthe blades (A) and (B), so that they contact the sides (C)and (D). Then tighten the wing nuts.123 45002589Immerse the dressing stone in water for 2 or 3 minutesbefore sharpening. Hold the holder so that the bothblades contact the dressing stone for simultaneoussharpening at the same angle.1. Wing nut2. Blade (A)3. Blade (B)4. Side (D)5. Side (C)1. Sharpeningholder1. End2. Start1. Nozzle2. Vacuum cleaner1. Nozzle2. Screwdriver