Makita 3600BR Instruction Manual

Contents

Straight guideThe straight guide is effectively used forstraight cuts when chamfering or grooving.i'III:Iii Install the straight guide on the guideI, holder with the wing bolt (8). Tighten theI: wing bolt (8) only tight enough to hold theI',il straight guide temporarily. Then insert theI' guide holder into the holes in the tool baseI: and tighten the wing bolts (A). Adjust theI' distance between the bit and the straightguide by turning the fine adjusting screwIii (1.5 mm or about 1/16" per turn). At thedesired distance, tighten the wing bolt (8)II: to secure the straight guide in place.II'i When cutting, move the tool with the straight guide flush with the side of the workpiece.Straight guideWing bolt 'IA),,Wider straight guide of desired dimensionsmay be made by using the convenient holes, in the guide to bolt on extra pieces ofi lwood.I When using a board-jointing bit, attachI pieces of wood to the straight guidewhich have a thickness of more than15 mm (5/8") so that the bit does notstrike the straight guide.More than15 mm (5/8");:>.._~ J:J7 ~'5(m:--7~ .lJ~ _~(2-3116")5(m:--Y(2-3/16")8