2SPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to changewithout notice.• Note: Specifications may differ from country to country.SYMBOLS END201-1The following show the symbols used for the tool. Besure that you understand their meaning before use....................Read instruction manual....................DOUBLE INSULATIONIntended useThe tool is intended for flush trimming and profiling ofwood, plastic and similar materials.Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire.For European countries onlyNoise and VibrationThe typical A-weighted noise levels aresound pressure level: 94 dB (A)sound power level: 105 dB (A)Uncertainty: 3 dB(A)– Wear ear protection. –The typical weighted root mean square accelerationvalue is not more than 2.5 m/s2.These values have been obtained according toEN60745.EC-DECLARATION OF CONFORMITYWe declare under our sole responsibility that this productis in compliance with the following standards of stand-ardized documents, EN60745, EN55014, EN61000 inaccordance with Council Directives, 73/23/EEC, 89/336/EEC, 98/37/EC.Yasuhiko Kanzaki CE 2004DirectorMAKITA INTERNATIONAL EUROPE LTD.Michigan Drive, Tongwell, Milton Keynes, Bucks MK158JD, ENGLANDResponsible manufacturer:Makita Corporation Anjo Aichi JapanModel 3601BCollet chuck capacity 12 mmNo load speed (min-1 ) 23,000Overall height 190 mmNet weight 3.5 kgSafety class /II