Makita 3601B Instruction Manual

Also see for 3601B: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

8Secure the templet to the workpiece. Place the tool on the templet and movethe tool with the templet guide sliding along the side of the templet.NOTE:• The workpiece will be cut a slightly different size from the templet. Allowfor the distance (X) between the bit and the outside of the templet guide.The distance (X) can be calculated by using the following equation:Distance (X) = (outside diameter of the templet guide - bit diameter) / 2Trimmer guide (Accessory)Trimming, curved cuts in veneers for furniture and the like can be done easilywith the trimmer guide. The guide roller rides the curve and assures a fine cut.Install the trimmer guide on the tool base with the wing bolts (B). Loosen thewing bolt (A) and adjust the distance between the bit and the trimmer guide byturning the fine adjusting screw (1.5 mm per turn). At the desired distance,tighten the wing bolt (A) to secure the trimmer guide in place. When adjustingthe guide roller up or down, loosen the wing bolt (C). After adjusting it, tightenthe wing bolt (C) securely.1. Bit2. Base3. Templet4. Workpiece5. Distance (X)6. Outside diameter of the templetguide7. Templet guide1234 5670036950050471. Wing bolt (B)2. Fine adjusting screw3. Wing bolt (A)4. Trimmer guide5. Wing bolt (C)6. Guide roller123 4 56005048