7tighten the wing bolt (C) securely.123 4 56005048When cutting, move the tool with the guide roller ridingthe side of the workpiece.312003701Connecting a vacuum cleaner120062861234 5006287Connect a vacuum hose to the tool and further connectanother end of it to the vacuum cleaner. Secure the hoseto the router base with a screw in the figure.1 2 35 4006288Connect another and of the hose to the vacuum cleanerhose of 38 mm in inner diameter using a joint.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.Replacing carbon brushes1001145Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the rear cover.12005049Use a screwdriver to remove the brush holder caps.Take out the worn carbon brushes, insert the new onesand secure the brush holder caps.1. Screwdriver2. Rear cover1. Limit mark1. Hose2. Joint3. Vacuum hose4. Outer diameterφ32 mm5. Inner diameterφ38 mm1. Screwdriver2. Screw3. Hole4. Vacuum hose5. Router base1. Vacuum hose2. Vacuum cleaner1. Bit2. Guide roller3. Workpiece1. Wing bolt (B)2. Fine adjustingscrew3. Wing bolt (A)4. Trimmer guide5. Wing bolt (C)6. Guide roller