Makita 3709 Instruction Manual

Also see for 3709: Parts Breakdown Instruction manual Instruction manual Instruction manual Instruction manual

Contents

410. Before using the tool on an actual workpiece,let it run for a while. Watch for vibration orwobbling that could indicate improperlyinstalled bit.11. Be careful of the bit rotating direction and thefeed direction.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to cometo a complete stop before removing the toolfrom workpiece.14. Do not touch the bit immediately afteroperation; it may be extremely hot and couldburn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They maycause cracks in the tool base.16. Use bits of the correct shank diameter suitablefor the speed of the tool.17. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.18. Always use the correct dust mask/respiratorfor the material and application you areworking with.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury. USD201-2SymbolsThe followings show the symbols used for tool.･ volts･ amperes･ hertz･ alternating current･ no load speed･ Class II Construction･ revolutions or reciprocation per minuteFUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Adjusting bit protrusion12345006613To adjust the bit protrusion, loosen the clamping nut andmove the tool base up or down as desired by turning theadjusting screw. After adjusting, tighten the clamping nutfirmly to secure the tool base.Switch action1006614CAUTION:• Before plugging in the tool, always be sure that thetool is switched off.To start the tool, move the switch lever to the I (ON)position. To stop the tool, move the switch lever to the O(OFF) position.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.1. Switch lever1. Base2. Scale3. Bit protrusion4. Clamping nut5. Adjusting screw

/ 28

Related manuals for Makita 3709

Makita 3709 Instruction Manual

This manual is suitable for:

3709

manualsdatabase

Your AI-powered manual search engine