Makita 3709 User Manual

Also see for 3709: Parts Breakdown Instruction manual Instruction manual Instruction manual Instruction manual

9Remove the chip deflector.Attach the straight guide with the clamp screw (A). Loosen the wing nut on thestraight guide and adjust the distance between the bit and the straight guide.At the desired distance, tighten the wing nut securely.When cutting, move the tool with the straight guide flush with the side of theworkpiece.If the distance (A) between the side of the workpiece and the cutting position istoo wide for the straight guide, or if the side of the workpiece is not straight, thestraight guide cannot be used. In this case, firmly clamp a straight board to theworkpiece and use it as a guide against the trimmer base. Feed the tool in thedirection of the arrow.Circular workCircular work may be accomplished if you assemble the straight guide andguide plate as shown in the figures.Min. and max. radius of circles to be cut (distance between the center of circleand the center of bit) are as follows:Min.: 70 mmMax.: 221 mmFor cutting circles between 70 mm and 121 mm in radius.For cutting circles between 121 mm and 221 mm in radius.NOTE:• Circles between 172 mm and 186 mm in radius cannot be cut using thisguide.1. Clamp screw (A)2. Straight guide3. Wing nut4. Base1234006624A0066181. Wing nut2. Guide plate3. Straight guide4. Center hole5. Bolt123450066191. Wing nut2. Guide plate3. Straight guide4. Center hole5. Bolt12345006620