Makita 4331D Instruction Manual

Also see for 4331D: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

Contents

11Loosen the bolt on the back of the base with the hex wrench. Move the baseso that the bolt is positioned in the center of the cross-shaped slot in the base.Tilt the base until the desired bevel angle is obtained. The edge of the motorhousing indicates the bevel angle by graduations. Then tighten the bolt tosecure the base.Front flush cutsLoosen the bolt on the back of the base with the hex wrench and slide thebase all the way back. Then tighten the bolt to secure the base.CutoutsCutouts can be made with either of two methods A or B.A) Boring a starting holeFor internal cutouts without a lead-in cut from an edge, pre-drill a startinghole 12 mm or more in diameter. Insert the blade into this hole to startyour cut.1. Cross-shaped slot2. Hex wrench3. Bolt1230027521. Edge of motor housing2. Graduations3. Base12 30027530027581. Starting hole1002763