Makita 4331D Instruction Manual

Also see for 4331D: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

Contents

9Plastic base plate (optional accessory)Use the plastic base plate when cutting decorative veneers, plastics, etc. Itprotects sensitive surfaces from damage. To replace the base plate, removethe four screws.Rip fence (optional accessory)When cutting widths of under 150 mm repeatedly, use of the rip fence (guiderule) will assure fast, clean, straight cuts. To install it, loosen the bolt on thefront of the base. Slip in the rip fence and secure the bolt.Circular guide (optional accessory)Use of the circular guide insures clean, smooth cutting of circles under200 mm in radius. Insert the pin through the center hole and secure it with thethreaded knob. Move the base of the tool forward fully. Then install the circularguide on the base in the same manner as the rip fence (guide rule).Plastic cover and vacuum head (optional accessory)The vacuum head is recommended to perform clean cutting operations. Installthe plastic cover on the tool by fitting it into the notches in the tool.1. Screw2. Plastic base plate3. Hex wrench1230027351. Hex wrench2. Rip fence (Guide rule)3. Bolt1230027371. Threaded knob2. Circular guide3. Pin1230027391. Notches2. Base3. Plastic cover123002740