3ENGLISH (Original instructions)Explanation of general view1-1. Switch trigger1-2. Lock button2-1. Counterclockwise2-2. Switch trigger2-3. Clockwise4-1. Chuck key5-1. Tighten5-2. Sleeve5-3. Ring7-1. Limit mark8-1. Brush holder cap8-2. ScrewdriverSPECIFICATIONSModel 6013B 6013BRSteel 13 mm 13 mmCapacities Wood 36 mm 36 mmNo load speed (min -1) 550 550Overall length 340 mm 340 mmNet weight 2.9 kg 2.9 kgSafety class /II• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003ENE032-1Intended useThe tool is intended for drilling in wood, metal andplastic. ENF002-1Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated in accordance with EuropeanStandard and can, therefore, also be used from socketswithout earth wire. ENG102-3NoiseThe typical A-weighted noise level determined accordingto EN60745:Sound pressure level (LpA) : 86 dB(A)Sound power level (LWA) : 97 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protection ENG202-3VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Work mode: drilling into metalVibration emission (ah,D) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-13For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:DrillModel No./ Type: 6013B,6013BRare of series production andConforms to the following European Directives:98/37/EC until 28th December 2009 and then with2006/42/EC from 29th December 2009And are manufactured in accordance with the followingstandards or standardised documents:EN60745The technical documentation is kept by our authorisedrepresentative in Europe who is:Makita International Europe Ltd,Michigan, Drive, Tongwell,Milton Keynes, MK15 8JD, England30th January 2009000230Tomoyasu KatoDirector