Makita 6908D Instruction Manual

Also see for 6908D: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

4ENGLISHExplanation of general view1 Button2 Battery cartridge3 Bit4 Sleeve5 Switch trigger6 Reversing switch lever7 A side8 B side9 Clockwise10 Counterclockwise11 Kg•cm12 Fastening torque13 Proper fastening torque for14 Seconds15 Fastening time16 Limit mark17 Screwdriver18 Brush holder capSPECIFICATIONSModel 6908DCapacitiesMachine screw ................................................ M4 – M8Standard Bolt ................................................. M5 – M12High tensile bolt ............................................. M5 – M10No load speed (min–1 ) ....................................... 0 – 2,200Impacts per minute ............................................ 0 – 2,800Overall length ......................................................171 mmNet weight ..............................................................1.4 kgRated voltage ...................................................D.C. 9.6 V• Due to the continuing program of research and devel-opment, the specifications herein are subject to changewithout prior notice.• Note : Specifications may differ from country to country.Intended useThe tool is intended for screw driving in wood, metal andplastic.Safety hintsFor your own safety, please refer to the enclosed safetyinstructions.IMPORTANT SAFETY INSTRUCTIONS FORCHARGER & BATTERY CARTRIDGEENC004-11. Before using battery cartridge, read all instruc-tions and cautionary markings on (1) batterycharger, (2) battery, and (3) product using bat-tery.2. Do not disassemble battery cartridge.3. If operating time has become excessivelyshorter, stop operating immediately. It mayresult in a risk of overheating, possible burnsand even an explosion.4. If electrolyte gets into your eyes, rinse them outwith clear water and seek medical attention rightaway. It may result in loss of your eyesight.5. Always cover the battery terminals with the bat-tery cover when the battery cartridge is notused.6. Do not short the battery cartridge:(1) Do not touch the terminals with any conduc-tive material.(2) Avoid storing battery cartridge in a containerwith other metal objects such as nails, coins,etc.(3) Do not expose battery cartridge to water orrain.A battery short can cause a large current flow,overheating, possible burns and even a break-down.7. Do not store the tool and battery cartridge inlocations where the temperature may reach orexceed 50°C (122°F).8. Do not incinerate the battery cartridge even if itis severely damaged or is completely worn out.The battery cartridge can explode in a fire.9. Be careful not to drop or strike battery.SAVE THESE INSTRUCTIONS.Tips for maintaining maximum battery life1. Charge the battery cartridge before completelydischarged.Always stop tool operation and charge the bat-tery cartridge when you notice less tool power.2. Never recharge a fully charged battery cartridge.Overcharging shortens the battery service life.3. Charge the battery cartridge with room tempera-ture at 10°C – 40°C (50°F – 104°F). Let a hot bat-tery cartridge cool down before charging it.4. Charge the Nickel Metal Hydride battery car-tridge when you do not use it for more than sixmonths.ADDITIONAL SAFETY RULESENB024-11. Be aware that this tool is always in an operatingcondition, because it does not have to beplugged into an electrical outlet.2. Hold tool by insulated gripping surfaces whenperforming an operation where the cutting toolmay contact hidden wiring. Contact with a “live”wire will also make exposed metal parts of thetool “live” and shock the operator.3. Always be sure you have a firm footing. Be sureno one is below when using the tool in high loca-tions.4. Hold the tool firmly.5. Wear ear protectors.SAVE THESE INSTRUCTIONS.