Makita 6951 Instruction Manual

Also see for 6951: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

3ENGLISHExplanation of general viewSPECIFICATIONS• Due to our continuing program of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2014END201-7SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use..... Read instruction manual............... DOUBLE INSULATIONENE033-1Intended useThe tool is intended for screw driving in wood, metal andplastic.ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated and can, therefore, also be used fromsockets without earth wire.GEA012-2General power tool safetywarningsWARNING: Read all safety warnings, instructions,illustrations and specifications provided with thispower tool. Failure to follow all instructions listed belowmay result in electric shock, fire and/or serious injury.Save all warnings andinstructions for future reference.The term “power tool” in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.Work area safety1. Keep work area clean and well lit. Cluttered or darkareas invite accidents.2. Do not operate power tools in explosiveatmospheres, such as in the presence offlammable liquids, gases or dust. Power toolscreate sparks which may ignite the dust or fumes.3. Keep children and bystanders away whileoperating a power tool. Distractions can cause youto lose control.Electrical Safety1. Power tool plugs must match the outlet. Nevermodify the plug in any way. Do not use anyadapter plugs with earthed (grounded) powertools. Unmodified plugs and matching outlets willreduce risk of electric shock.2. Avoid body contact with earthed or groundedsurfaces, such as pipes, radiators, ranges andrefrigerators. There is an increased risk of electricshock if your body is earthed or grounded.3. Do not expose power tools to rain or wetconditions. Water entering a power tool will increasethe risk of electric shock.4. Do not abuse the cord. Never use the cord forcarrying, pulling or unplugging the power tool.Keep cord away from heat, oil, sharp edges ormoving parts. Damaged or entangled cords increasethe risk of electric shock.1. Switch trigger2. Reversing switch lever3. Bit4. Sleeve5. Bit-piece6. Limit mark7. Screwdriver8. Brush holder capModel 6951CapacitiesMachine screw 4 mm - 8 mmStandard bolt 6 mm - 12 mmHigh tensile bolt 6 mm - 12 mmNo load speed (min -1) 0 - 2,200Impacts per minute 0 - 3,000Max. fastening torque 98 N•mOverall length 239 mmNet weight 1.3 kgSafety class /II