Makita BBX7600 Instruction Manual

Also see for BBX7600: Catalog Instruction manual Parts Breakdown Specifications Instruction manual

132) When the engine is warm(1) Place the engine on a flat ground.(2) Press the primary pump several times.(3) Confirm that the choke lever is open.(4) Hold the element cover with a left hand to prevent the engine from moving, settle down to take the stable position.(5) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it outwith force.(6) When the engine is difficult to start, open the throttle valve by about 1/3.2. Stopping1) When the cruise control lever is a Low-speed position.Release the trigger lever to reduce the engine speed, and set the stopswitch to the “O” position.2) When the cruise control lever is except a Low-speed position.Set the cruise control lever to the Low-speed position, reduce theengine speed, and set the stop switch to the “O” position.ADJUSTMENT OF IDLINGCheckup of low-speed rotationSet the low-speed rotation to 2800min-1.• If it is necessary to change the rotation speed, regulate the adjustingscrew, with Phillips screwdriver.• Turn the adjusting screw to the right, and the engine rotation willincrease. Turn the adjusting screw to the left, and the engine rotationwill drop.NOTE• The engine may be damaged if the choke lever is moved further beyond the “CLOSE” position.• If the engine stops with an explosion sound or if the engine started, but stopped before operation of the choke lever, return this lever tothe “OPEN” position and pull the starter handle several times to start the engine again.• If the operator keeps pulling the starter handle several times with the choke lever left in the “CLOSE” position, the engine may be difficultto start because of over-suction of the fuel.• In case of over-suction of the fuel, remove the spark plug and pull the handle several times rapidly to discharge any excess fuel. Dry thespark plug electrode.• When the throttle valve does not return to a position in contact with the idling adjusting screw even if the throttle lever is set to the lowspeed, correct the control cable catching state to ensure proper return of the valve.DANGERThe carburetor is the adjustment being completed at the time of factory shipment. Please do not adjust other than idling adjusting. Whenadjustment becomes necessary, please consult your dealership or an authorized service agent.Stop SwitchCruise control lever Hi-speedLow-speedAdjusting screwCarburetor