Makita BJV140 Instruction Manual

Also see for BJV140: Instruction manual Instruction manual Instruction manual Instruction manual Technical information

Contents

Makita BJV140 Instruction Manual Manual pdf 10 page image

10To trim edges or make dimensional adjustments, run theblade lightly along the cut edges.Metal cuttingAlways use a suitable coolant (cutting oil) when cuttingmetal. Failure to do so will cause significant blade wear.The underside of the workpiece can be greased insteadof using a coolant.Rip fence set (optional accessory)CAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before installing orremoving accessories.1. Straight cuts1007496123007497When repeatedly cutting widths of 160 mm or less, use ofthe rip fence will assure fast, clean, straight cuts. Toinstall, insert the rip fence into the rectangular hole on theside of the tool base with the fence guide facing down.Slide the rip fence to the desired cutting width position,then tighten the bolt to secure it.2. Circular cuts007498123007499When cutting circles or arcs of 170 mm or less inradius, install the rip fence as follows.• Insert the rip fence into the rectangular hole on theside of the base with the fence guide facing up.Insert the circular guide pin through either of thetwo holes on the fence guide. Screw the threadedknob onto the pin to secure the pin.• Now slide the rip fence to the desired cutting radius,and tighten the bolt to secure it in place. Then movethe base all the way forward.NOTE:• Always use blades No. B-17, B-18, B-26 or B-27when cutting circles or arcs.Guide rail adapter set (accessory)007500When cutting parallel and uniform width or cuttingstraight, the use of the guide rail and the guide railadapter will assure the production of fast and clean cuts.To install the guide rail adapter, insert the rule bar into thesquare hole of the base as far as it goes. Secure the boltwith the hex wrench securely.1 2007501Install the guide rail adapter on the rail of the guide rail.Insert the rule bar into the square hole of the guide railadapter. Put the base to the side of the guide rail, andsecure the bolt securely.1. Bolt2. Rule bar1. Fence guide2. Threaded knob3. Circular guidepin1. Hex wrench2. Bolt3. Fence guide1. Rip fence

/ 12

Related manuals for Makita BJV140