Makita BTD130F Instruction Manual

Also see for BTD130F: Instruction manual Instruction manual Parts list Instruction manual Instruction manual

Contents

Makita BTD130F Instruction Manual Manual pdf 5 page image

5power.2. Never recharge a fully charged batterycartridge.Overcharging shortens the battery service life.3. Charge the battery cartridge with roomtemperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).Let a hot battery cartridge cool down beforecharging it.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before adjusting orchecking function on the tool.Installing or removing battery cartridge123006667• Always switch off the tool before insertion orremoval of the battery cartridge.• To remove the battery cartridge, withdraw it fromthe tool while sliding the button on the front of thecartridge.• To insert the battery cartridge, align the tongue onthe battery cartridge with the groove in the housingand slip it into place. Always insert it all the wayuntil it locks in place with a little click. If you cansee the red part on the upper side of the button, itis not locked completely. Insert it fully until the redpart cannot be seen. If not, it may accidentally fallout of the tool, causing injury to you or someonearound you.• Do not use force when inserting the batterycartridge. If the cartridge does not slide in easily, itis not being inserted correctly.Switch action1006246CAUTION:• Before inserting the battery cartridge into the tool,always check to see that the switch triggeractuates properly and returns to the "OFF" positionwhen released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.Lighting up the front lamp1006247CAUTION:• Do not look in the light or see the source of lightdirectly.Pull the switch trigger to light up the lamp. The lampkeeps on lighting while the switch trigger is being pulled.The light automatically goes out 10 - 15 seconds afterthe switch trigger is released.NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of lamp, or it maylower the illumination.1. Lamp1. Switch trigger1. Red part2. Button3. Batterycartridge