3ENGLISH (Original instructions)Explanation of general view1-1. Buttons1-2. Battery2-1. Clamping screw2-2. Depth guide3-1. Clamping screw3-2. Bevel scale plate4-1. Cutting line5-1. Lock-off lever5-2. Switch trigger6-1. Shaft lock6-2. Hex wrench6-3. Tighten6-4. Loosen7-1. Inner flange7-2. Diamond wheel7-3. Outer flange7-4. Hex bolt8-1. Hex bolt8-2. Outer flange8-3. Diamond wheel8-4. Inner flange8-5. Protrusion (bigger side)9-1. Hex wrench10-1. Tank holder10-2. ScrewA10-3. Notch10-4. Motor housing11-1. ScrewB11-2. Tank11-3. Tube12-1. Cap12-2. Open13-1. Water supply cock13-2. Close13-3. OpenSPECIFICATIONSModel CC300DDiamond wheel diameter 85 mmMax. wheel thickness 0.8 mmat 0° 25.5 mmMax. Cutting depth at 45° 16.5 mmRated speed (n) / No load speed (n 0) 1,400 (min -1)Overall length 300 mmRated voltage D.C. 10.8 VNet weight 1.7 kg• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications and battery cartridge may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003ENE025-1Intended useThe tool is intended for cutting in glass and masonrymaterials with a diamond wheel and water. ENG905-1NoiseThe typical A-weighted noise level determined accordingto EN60745:Sound pressure level (LpA) : 83 dB (A)Sound power level (LWA) : 94 dB (A)Uncertainty (K) : 3 dB (A)Wear ear protectionENG900-1VibrationThe vibration total value (tri-axial vector sum) determinedaccording to EN60745:Work mode : concrete cuttingVibration emission (ah ) : 2.5 m/s 2Uncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-16For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:Cordless CutterModel No./ Type: CC300Dare of series production and