Makita CL108FDWYW Instruction Manual

Also see for HP333D: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISHCAUTION: Only use genuine Makita batteries.Use of non-genuine Makita batteries, or batteries thathave been altered, may result in the battery burstingcausing fires, personal injury and damage. It willalso void the Makita warranty for the Makita tool andcharger.Tips for maintaining maximumbattery life1. Charge the battery cartridge before completelydischarged. Always stop tool operation andcharge the battery cartridge when you noticeless tool power.2. Never recharge a fully charged battery car-tridge. Overcharging shortens the batteryservice life.3. Charge the battery cartridge with room tem-perature at 10 °C - 40 °C (50 °F - 104 °F). Leta hot battery cartridge cool down beforecharging it.FUNCTIONALDESCRIPTIONCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore adjusting or checking function on the tool.CAUTION: Take care not to trap finger(s)between cleaner and battery as shown in diagramwhen loading battery. Trapping finger(s) may causeinjury.Installing or removing batterycartridgeCAUTION: Always switch off the tool beforeinstalling or removing of the battery cartridge.CAUTION: Hold the tool and the battery car-tridge firmly when installing or removing batterycartridge. Failure to hold the tool and the batterycartridge firmly may cause them to slip off your handsand result in damage to the tool and battery cartridgeand a personal injury.123► 1. Red indicator 2. Button 3. Battery cartridgeTo remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert it all the way until it locks in placewith a little click. If you can see the red indicator on theupper side of the button, it is not locked completely.CAUTION: Always install the battery cartridgefully until the red indicator cannot be seen. If not,it may accidentally fall out of the tool, causing injury toyou or someone around you.CAUTION: Do not install the battery cartridgeforcibly. If the cartridge does not slide in easily, it isnot being inserted correctly.Battery protection systemThe tool is equipped with a battery protection system.This system automatically cuts off power to the motor toextend battery life.The tool will automatically stop during operation if thetool and/or battery are placed under one of the followingconditions:Overloaded:The tool is operated in a manner that causes it to drawan abnormally high current.In this situation, turn the tool off and stop the applicationthat caused the tool to become overloaded. Then turnthe tool on to restart.Low battery voltage:The remaining battery capacity is too low and the toolwill not operate. If you turn the tool on, the motor runsagain but stops soon. In this situation, remove andrecharge the battery.