Makita DBC3310 Owner's And Safety Manual

Makita DBC3310 Owner's And Safety Manual Manual pdf 16 page image

16Putting into operation- Move the switch (G/6) in the direction of the arrow.- To set the half-throttle catch, press the throttle (G/8) withthe throttle trigger lockout (G/7) pressed and then pressthe catch (G/10). Release the throttle (G/8) and then thethrottle trigger lockout (G/7).Cold startH- Turn the choke lever (H/9) downwards to choke the engine.9I- Hold the brushcutter frimly down with one hand, asillustrated above.- Pull the starter handle out slowly until resistance is noticed,then pull the starter handle out fully with a quick and forcefulmovement.- Do not pull out the whole starter cable to its full extent anddo not let the starter handle jump back, but let it slowlyautomatically rewind itself.- Repeat starting procedure until ignition is achieved.- Turn the choke lever (H/9) back up and pull the startercable again until the engine starts.- After the engine has started, press the throttle (J/8) all theway in and release immediately. This will disengage thehalf-throttle position.- Run the engine for approximately 1 minute at a moderatespeed before commencing work.Warm startSimilar to a cold start but without the choke.Turning off the engineMove switch (J/6) to the position .STOPObserve accident-prevention regulations!Do not start the brushcutter until fully assembled andinspected!Starting the engine- Move at least 10 feet (3 meters) away from where you filledthe fuel tank.- Make sure you have a good footing, and lay the brushcutteron the ground in such a way that the cutting tool is nottouching the ground or anything else.G86710J68