Makita DBC3310 Owner's And Safety Manual

Makita DBC3310 Owner's And Safety Manual Manual pdf 19 page image

19Trimmer headLengthening the lineA- Hold the housing (A/1) firmly and pull the housing cover(A/2) out against the spring pressure in the direction of thearrow (figure) until it is possible to turn the cover (A/2)counter-clockwise.- Stop pulling out on the cover (A/2) and turn itcounter-clockwise until it snaps back in.- Pull the line ends (A/3) out as far as they will go. Repeatthis procedure until you have about 6" (15 cm) of lineavailable.A detailed description of this adjustment is included with thetrimmer head.123Starter cable replacementB- Unscrew the ventilator housing.- Screw out the center screw (B/4).- Remove the guide disk (B/5) complete with the starterratchet and the brake spring.- Remove the pawl spring (B/6).CSTOP546 78D- Push the starter cable through the guide hole (D/9) andthen feed the cable through the opening in the drum andtie a knot as shown above.- Press the knotted end of the starter cable (D/10) into theappropriate slot in the drum.- Feed the other cable end through the handle and securewith the knot shown in (D/11).- Wind the cable onto the drum for about 3 1/4 turns. Payattention to the correct direction of rotation (counter-clockwise when assembled).91110- Pull out the starter handle and starter cable to length ofabout 12" (30 cm).- Hold the starter cable drum and pull out the starter cableusing a screw driver or similar tool.- Let the drum slowly turn backwards (in the direction of thearrow) with the starter cable in the appropriate slot (C/7)until the tension in the spring has been released.- Remove the drum (C/8).- If starter cable has split or frayed, remove it from the drum.- Lubricate the center shaft of the starter cable drum with amultipurpose grease (Part no. 944 360 000) beforecommencing re-assembly.SchematicE- Put the starter cable drum into the housing and check tomake sure the return spring is hooked in the correct positionby turning it slightly counter-clockwise.- Insert the pawl spring (E/12) into the starter cable drum asshown.12