10MAINTENANCECAUTION:• Always be sure that the tool is switched off and thebattery cartridge and nails are removed beforeattempting to perform inspection or maintenance.• Never use gasoline, benzine, thinner, alcohol or thelike. Discoloration, deformation or cracks may result.Cleaning of magazineWhen the pusher in the magazine does not movesmoothly because of dust, sand, chips or other foreignmatters, clean the magazine.Fig.18To remove the slide door, loosen the hex bolt on themagazine.Fig.19Pull the pusher from the slide door and then remove thestopper, sleeves and springs.After cleaning, install the whole parts into the slide door.To install them, take the following procedure.1. Install the large spring into the slide door.2. Install the parts onto the pusher in the correctorder, sleeve, small spring and then stopper.3. Install the pusher with the other parts onto theslide door.NOTE:• When you pull out the pusher from the slide door,the parts in the slide door may bounce out.• When you install the pusher with the other parts tothe slide door, make slight spaces between thepusher and sleeves.To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers,always using Makita replacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments are recommendedfor use with your Makita tool specified in this manual.The use of any other accessories or attachments mightpresent a risk of injury to persons. Only use accessoryor attachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.• Nails• Makita genuine battery and charger• Safety gogglesNOTE:• Some items in the list may be included in the toolpackage as standard accessories. They may differfrom country to country.