Makita DDF484RFJ Instruction Manual

Also see for DDF484: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

6 ENGLISHFUNCTIONALDESCRIPTIONCAUTION: Always be sure that the tool isswitched off and the battery cartridge is removedbefore adjusting or checking function on the tool.Installing or removing batterycartridgeCAUTION: Always switch off the tool beforeinstalling or removing of the battery cartridge.CAUTION: Hold the tool and the battery cartridgefirmly when installing or removing battery cartridge.Failure to hold the tool and the battery cartridge firmly maycause them to slip off your hands and result in damage tothe tool and battery cartridge and a personal injury.► Fig.1: 1. Red indicator 2. Button 3. Battery cartridgeTo remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert it all the way until it locks in placewith a little click. If you can see the red indicator on theupper side of the button, it is not locked completely.CAUTION: Always install the battery cartridgefully until the red indicator cannot be seen. If not,it may accidentally fall out of the tool, causing injury toyou or someone around you.CAUTION: Do not install the battery cartridgeforcibly. If the cartridge does not slide in easily, it isnot being inserted correctly.Indicating the remaining batterycapacityOnly for battery cartridges with "B" at the end of themodel number► Fig.2: 1. Indicator lamps 2. Check buttonPress the check button on the battery cartridge to indi-cate the remaining battery capacity. The indicator lampslight up for few seconds.Indicator lamps RemainingcapacityLighted Off Blinking75% to 100%50% to 75%25% to 50%0% to 25%Charge thebattery.Indicator lamps RemainingcapacityLighted Off BlinkingThe batterymay havemalfunctioned.NOTE: Depending on the conditions of use and theambient temperature, the indication may differ slightlyfrom the actual capacity.Tool / battery protection systemThe tool is equipped with a tool/battery protection sys-tem. This system automatically cuts off power to themotor to extend tool and battery life. The tool will auto-matically stop during operation if the tool or battery isplaced under one of the following conditions:Overload protectionWhen the tool/battery is operated in a manner that causesit to draw an abnormally high current, the tool automat-ically stops without any indication. In this situation, turnthe tool off and stop the application that caused the tool tobecome overloaded. Then turn the tool on to restart.Overheat protectionWhen the tool/battery is overheated, the tool stopsautomatically. In this situation, let the tool/battery coolbefore turning the tool on again.Overdischarge protectionWhen the battery capacity is not enough, the tool stopsautomatically. In this case, remove the battery from thetool and charge the battery.NOTE: Overheat protection (for battery) will work onlywith batteries with star marking.► Fig.3: 1. Star markingSwitch action► Fig.4: 1. Switch triggerCAUTION: Before installing the battery car-tridge into the tool, always check to see that theswitch trigger actuates properly and returns tothe "OFF" position when released.To start the tool, simply pull the switch trigger. Toolspeed is increased by increasing pressure on the switchtrigger. Release the switch trigger to stop.NOTE: The tool automatically stops if you keep pull-ing the switch trigger for about 6 minutes.Lighting up the front lamp► Fig.5: 1. LampCAUTION: Do not look in the light or see thesource of light directly.