Makita DHP486 Instruction Manual

Also see for DHP486: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DHP486Drilling capacities Masonry 16 mmSteel 13 mmWood Auger bit: 50 mmSelf-feed bit: 76 mmHole saw: 152 mmFastening capacities Wood screw 10 mm x 90 mmMachine screw M6No load speed (RPM) High (2) 0 - 2,100 min -1Low (1) 0 - 550 min -1Blows per minute High (2) 0 - 31,500 min -1Low (1) 0 - 8,250 min -1Overall length 178 mmRated voltage D.C. 18 VNet weight 2.3 - 2.7 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /DC18SH• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for impact drilling in brick, brickworkand masonry. It is also suitable for screw driving anddrilling without impact in wood, metal, ceramic andplastic.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-1:Sound pressure level (LpA ) : 84 dB(A)Sound power level (LWA ) : 95 dB (A)Uncertainty (K) : 3 dB(A)NOTE: The declared noise emission value(s) hasbeen measured in accordance with a standard testmethod and may be used for comparing one tool withanother.NOTE: The declared noise emission value(s)may also be used in a preliminary assessment ofexposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which the tool isused especially what kind of workpiece is processed.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (tak-ing account of all parts of the operating cycle suchas the times when the tool is switched off and whenit is running idle in addition to the trigger time).VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-1:Work mode: impact drilling into concreteVibration emission (a h,ID ) : 8.0 m/s 2Uncertainty (K) : 1.5 m/s2Work mode: drilling into metalVibration emission (a h,D ) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s2