Makita DHS680 Instruction Manual

Also see for DHS680: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DHS680 Instruction Manual Manual pdf 6 page image

6 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel DHS680Blade diameter 165 mmMax. cutting depth at 0° 57 mmat 45° 41 mmat 50° 37 mmNo load speed 5,000 min -1Overall length 350 mmNet weight 3.0 - 3.3 kgRated voltage D.C. 18 V• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF• Some of the battery cartridges and chargers listed above may not be available depending on your region ofresidence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for performing lengthways andcrossways straight cuts and mitre cuts with angles inwood while in firm contact with the workpiece. Withappropriate Makita genuine saw blades, other materialscan also be sawed.NoiseThe typical A-weighted noise level determined accord-ing to EN62841:Sound pressure level (L pA ) : 94 dB (A)Sound power level (LWA ) : 105 dB (A)Uncertainty (K) : 3 dB (A)Wear ear protectionVibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841:Work mode : cutting woodVibration emission (a h,W ) : 2.5 m/s 2 or lessUncertainty (K) : 1.5 m/s 2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.General power tool safety warningsWARNING: Read all safety warnings, instruc-tions, illustrations and specifications providedwith this power tool. Failure to follow all instructionslisted below may result in electric shock, fire and/orserious injury.