Makita DLS713 Instruction Manual

Also see for DLS713: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

7SPECIFICATIONSModel DLS713Blade diameter 190 mmBlade body thickness 1.3 mm - 2.0 mmHole (arbor) diameter 20 mmMax. Miter angle Left 47°, Right 57°Max. Bevel angle Left 45°, Right 5°Max. Cutting capacities (H x W) with blade 190 mm in diameter.Bevel angleMiter angle 45° (left) 0° 5° (right)25 mm x 300 mm 52 mm x 300 mm 40 mm x 300 mm0° ----- * 60 mm x 265 mm (Note 1) -----25 mm x 212 mm 52 mm x 212 mm -----45° (left and right) ----- * 60 mm x 185 mm (Note 2) ---------- 52 mm x 163 mm -----57° (right) ----- * 60 mm x 145 mm (Note 3) -----No load speed (min -1) 2,200Dimensions (L x W x H) 655 mm x 430 mm x 454 mmNet weight 12.7 kgRated voltage D.C.18 V(Note)* mark indicates that a wood facing with the following thickness is used.1: When using a wood facing 20 mm thickness2: When using a wood facing 15 mm thickness3: When using a wood facing 10 mm thickness• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications and battery cartridge may differ from country to country.• Weight, with battery cartridge, according to EPTA-Procedure 01/2003END014-6SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.･ Read instruction manual.･ To avoid injury from flying debris, keepholding the saw head down, aftermaking cuts, until the blade has cometo a complete stop.･ When performing slide cut, first pullcarriage fully and press down handle, thenpush carriage toward the guide fence.･ Do not place hand or fingers close tothe blade.･ Always set SUB-FENCE to left positionwhen performing left bevel cuts. Failureto do so may cause serious injury tooperator.･ Only for EU countriesDo not dispose of electric equipment orbattery pack together with householdwaste material!In observance of the EuropeanDirectives, on Waste Electric andElectronic Equipment and Batteries andAccumulators and Waste Batteries andAccumulators and their implementationin accordance with national laws,electric equipment and batteries andbattery pack(s) that have reached theend of their life must be collectedseparately and returned to anenvironmentally compatible recyclingfacility. ENE076-1Intended useThe tool is intended for accurate straight and mitercutting in wood. ENG905-1NoiseThe typical A-weighted noise level determined accordingto EN61029:Sound pressure level (LpA) : 88 dB (A)Sound power level (LWA) : 98 dB (A)Uncertainty (K) : 3 dB (A)Wear ear protectionCdNi-MHLi-ion