Makita DPC 6400, DPC 6401, DPC 7300, DPC 7301 Instruction And Safety Manual

Makita DPC 6400, DPC 6401, DPC 7300, DPC 7301 Instruction And Safety Manual Manual pdf 15 page image

15CAUTION:Observe the SAFETY INSTRUCTIONS on page 5!Start the Power Cut only after complete assembly andinspection!Move at least 3m (10 feet) away from the place where youfuelled the Power Cut.Make sure you have a good footing, and place the PowerCut on the ground in such a way that the cutting disc is nottouching anything.D12Turn the hood lock (2) to position and hold it there.Pivot the hood (3) back as far as it will go.Release the hood lock and pivot the hood lightly back and forthuntil the lock engages.23ECold-startingMove the combination switch (5) up (choke position).Grasp handle (hand pressure actuates the grip throttlelever lock (7)).Push the throttle (8) in all the way and hold it.Press the throttle lock (6) and release the throttle (8) (thethrottle lock will hold the throttle at half-throttle position).NOTE: If the Power Cut is installed in the trolley, the controllever should be in the second arrest position.Push the starting valve (4).54678FGrasp the tubular handle firmly with one hand and press thePower Cut against the ground.Place the tip of your left foot in the rear handle.Pull the starter cable strong and rapidly until you hear the firstaudible ignition.CAUTION: Do not pull out the starter cable more than approx.50 cm (20"), and lead it back by hand.Press in the starting valve (F/4) again.Put the combination switch (F/5) in position “I”.Keep pulling the starter cable until the engine catches.As soon as the engine is running, press the throttle (F/8) torelease the half-throttle lock (F/6), allowing the engine to idle.Warm-startingAs described under ”Cold starting”, except without putting thecombination switch (F/5) in choke position.G3 meters(10 feet)