13 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DRT50Collet chuck capacity 6 mm, 8 mm, 1/4", or 3/8"No load speed 10,000 - 30,000 min -1Overall length 226 mmRated voltage D.C. 18 VStandard battery cartridge BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860BNet weight 1.8 - 2.1 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications and battery cartridge may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Intended useThe tool is intended for flush trimming and profiling ofwood, plastic and similar materials.NoiseThe typical A-weighted noise level determined accord-ing to EN60745:Sound pressure level (L pA ) : 78 dB(A)Uncertainty (K) : 3 dB(A)WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN60745:Work mode: rotation without loadVibration emission (ah) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2Work mode: cutting grooves in MDFVibration emission (ah) : 4.5 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value has beenmeasured in accordance with the standard test methodand may be used for comparing one tool with another.NOTE: The declared vibration emission value mayalso be used in a preliminary assessment of exposure.WARNING: The vibration emission during actualuse of the power tool can differ from the declaredemission value depending on the ways in which thetool is used.WARNING: Be sure to identify safety measuresto protect the operator that are based on an estima-tion of exposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when it isrunning idle in addition to the trigger time).EC Declaration of ConformityFor European countries onlyThe EC declaration of conformity is included as Annex Ato this instruction manual.SAFETY WARNINGSGeneral power tool safety warningsWARNING: Read all safety warnings, instruc-tions, illustrations and specifications providedwith this power tool. Failure to follow all instructionslisted below may result in electric shock, fire and/orserious injury.Save all warnings and instruc-tions for future reference.The term "power tool" in the warnings refers to yourmains-operated (corded) power tool or battery-operated(cordless) power tool.Cordless trimmer safety warnings1. Hold power tool by insulated gripping surfaces,because the cutter may contact hidden wiring.Cutting a "live" wire may make exposed metal partsof the power tool "live" and shock the operator.2. Use clamps or another practical way to secureand support the workpiece to a stable platform.Holding the work by your hand or against the bodyleaves it unstable and may lead to loss of control.3. Wear hearing protection during extendedperiod of operation.4. Handle the trimmer bits very carefully.5. Check the trimmer bit carefully for cracks ordamage before operation. Replace cracked ordamaged bit immediately.