Makita DST111 Instruction Manual

Also see for DST112: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita DST111 Instruction Manual Manual pdf 7 page image

7 ENGLISHOverdischarge protectionWhen the battery capacity is not enough, the tool stopsautomatically and the battery indicator shows followingstate. In this case, remove the battery from the tool andcharge the battery.On Off BlinkingIndicating the remaining batterycapacityOnly for battery cartridges with "B" at the end of themodel number► Fig.2: 1. Indicator lamps 2. Check buttonPress the check button on the battery cartridge to indi-cate the remaining battery capacity. The indicator lampslight up for few seconds.Indicator lamps RemainingcapacityLighted Off Blinking75% to 100%50% to 75%25% to 50%0% to 25%Charge thebattery.The batterymay havemalfunctioned.NOTE: Depending on the conditions of use and theambient temperature, the indication may differ slightlyfrom the actual capacity.Indicating the remaining batterycapacityCountry specificWhen you either pull the switch trigger or push the con-tact element, the battery indicator shows the remainingbattery capacity.► Fig.3: 1. Battery indicatorThe remaining battery capacity is shown as the follow-ing table.Battery indicator status RemainingbatterycapacityOn Off Blinking50% to 100%20% to 50%0% to 20%Charge thebatterySwitch actionCAUTION: Before installing the battery car-tridge into the tool, always check to see that theswitch trigger actuates properly and returns tothe "OFF" position when released.CAUTION: When not operating the tool,depress the trigger-lock button from B side tolock the switch trigger in the OFF position.► Fig.4: 1. Trigger-lock button 2. Switch trigger► Fig.5To prevent the switch trigger from accidentally pulled,the trigger-lock button is provided.To pull the switch trigger, depress the trigger-lock buttonfrom A side.After use, always press in the trigger-lock button fromB side.Lighting up the lampCAUTION: Do not look in the light or see thesource of light directly.► Fig.6: 1. LampPull the switch trigger or actuate the contact element tolight up the lamp. The lamp keeps on lighting while pull-ing the switch trigger or actuating the contact element.The lamp goes out approximately 10 seconds afterreleasing the switch trigger and the contact element.NOTE: Use a dry cloth to wipe the dirt off the lens ofthe lamp. Be careful not to scratch the lens of lamp, orit may lower the illumination.