Makita DTD154 Instruction Manual

Also see for DTD154: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

4 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: DTD154Fastening capacities Machine screw 4 mm - 8 mmStandard bolt 5 mm - 16 mmHigh tensile bolt 5 mm - 14 mmNo load speed Hard impact mode 0 - 3,600 min -1Medium impact mode 0 - 2,100 min -1Soft impact mode 0 - 1,100 min -1T mode 0 - 3,600 min -1Impacts per minute Hard impact mode 0 - 3,800 min -1Medium impact mode 0 - 2,600 min -1Soft impact mode 0 - 1,100 min -1T mode 0 - 2,600 min -1Rated voltage D.C. 18 VOverall length 117 mmNet weight 1.2 - 1.6 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combination, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /BL1840B / BL1850 / BL1850B / BL1860BCharger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF• Some of the battery cartridges and chargers listed above may not be available depending on your region ofresidence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for screw driving in wood, metaland plastic.NoiseThe typical A-weighted noise level determined accord-ing to EN62841:Sound pressure level (LpA) : 96 dB(A)Sound power level (LWA) : 107 dB (A)Uncertainty (K) : 3 dB(A)The noise level under working may exceed 80 dB (A).WARNING: Wear ear protection.VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841:Work mode: impact tightening of fasteners of the maxi-mum capacity of the toolVibration emission (ah) : 12.5 m/s2Uncertainty (K) : 1.5 m/s2NOTE: The declared vibration emission value hasbeen measured in accordance with the standard testmethod and may be used for comparing one tool withanother.NOTE: The declared vibration emission valuemay also be used in a preliminary assessment ofexposure.