Makita DTM50ZX5 Instruction Manual

Also see for DTM40: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9ASSEMBLYCAUTION:• Always be sure that the tool is switched off and thebattery cartridge is removed before carrying outany work on the tool.Installing or removing application tool(optional accessory)WARNING:• Do not install application tool upside down.Installing application tool upside down may damagethe tool and cause serious personal injury.• Install attachment tool in the correct directionaccording to your work. Application tool can beinstalled at an angle of every 30 degree.1320128261 23012767Put an application tool (optional accessory) on the toolflange so that the protrusions of the tool flange fit in theholes in the application tool and secure the applicationtool by tightening the bolt firmly with the hex wrench.When using sanding application tool, mount theapplication tool on the sanding pad so that it matches thesanding pad direction.The sanding pad has a hook and loop type fitting systemwhich allows easy and rapid fitting of a sanding paper.As sanding papers have holes for dust extraction, mounta sanding paper so that the holes in a sanding papermatch those in the sanding pad.To remove a sanding paper, raise its end and peel it off.Loosen and remove the application tool installation boltusing a hex wrench and then take off the application tool.1234012847When using application tools with a different type of installationsection, use a correct adapter (optional accessory).Hex wrench storage1012766When not in use, store the hex wrench as shown in thefigure to keep it from being lost.OPERATIONWARNING:• Before starting the tool and during operation, keepyour hand and face away from the application tool.CAUTION:• Do not apply excessive load to the tool which maycause a motor lock and stop the tool.Cutting, sawing and scrapingCAUTION:• Do not move on the tool forcibly in the direction (eg.towards either side) of tool application with nocutting edge. It may damage the tool.012801Put the application tool on the workpiece.And then move the tool forward so that the applicationtool movement does not slow down.1. Hex wrench1. Application toolinstallation bolt2. Holes in theapplication tool3. Adapter (requiredfor someapplication tools)4. Protrusions ofthe tool flange1. Application toolinstallation bolt2. Hex wrench3. Tighten1. Application toolinstallation bolt2. Holes in theapplication tool3. Protrusions ofthe tool flange

/ 12

Related manuals for Makita DTM40