Makita DTR180 Instruction Manual

Also see for DTR180: Instruction manual Instruction manual Original instructions Instruction manual Instruction manual

12 ENGLISHCAUTION: If you open the curl guide and turnthe power on to check the interlock, hold the curlguide as shown in the figure. Never bring yourlimbs or face close to the binding or rotating partsof the tool tip. Otherwise, you may be injured.Tying workCAUTION: Before inserting the battery car-tridge, be sure to release your fingers from theswitch trigger and lock the trigger. If you insertthe battery cartridge while the switch trigger is beingpulled, it may cause an accident if the wire tyingprocess is accidentally carried out.CAUTION: When you turn the power on, neverbring your limbs or face close to the binding orrotating parts of the tool tip. Otherwise, you maybe injured.CAUTION: When the power is turned on,never touch the binding or rotating parts of thetool tip. Otherwise, you may be injured.Preparation before work1. Make sure that the battery cartridge is removedand the trigger is locked.2. Insert the battery cartridge into the tool, and turnthe power on. When you turn the power on, the wire iscut automatically.NOTICE: Make sure that the tying mode lamplights up when the power is turned on. If it doesnot light up, recharge the battery.3. Release the trigger lock.4312► 1. Trigger-lock button 2. Switch trigger 3. Powerbutton 4. Tying mode lampSingle actuation mode1. Push the arm securely against the tying point.Push the tool vertically against the rebars, and pressthe arm against the point where the rebars cross at a45-degree angle.45°45°2. Pull the switch trigger once.3. The wire is fed and cut automatically.

/ 64

Related manuals for Makita DTR180

Makita DTR180 Instruction Manual

Makita DTR181 Instruction Manual

This manual is suitable for:

DTR180

manualsdatabase

Your AI-powered manual search engine