Makita EBH340R Instruction Manual

Also see for EBH340R: Instruction manual

Contents

Makita EBH340R Instruction Manual Manual pdf 14 page image

14(1)Observe all applicable accident prevention regulations!STARTINGMove at least 3 m away from the place of refuelling. Place the brushcutter on a clean piece of ground taking care that the cutting tool does notcome into contact with the ground or any other objects.A: Cold start1) Set this machine on a flat space.2) Move the throttle lever (1) to the start position (Low speed).3) Choke leverClose the choke lever.–Choke opening:–Full closing in cold or when the engine is cold.–Full or half opening in restart just after stop of operation.–4) Primer pumpContinue to push the primer pump until fuel enters into the primer pump.–(In general, fuel enters into the primer pump by 7 to 10 pushes.)If the primer pump is pushed excessively, an excess of gasoline returns to–the fuel tank.5) Recoil starterPull the start knob gently until it is hard to pull (compression point). Then,–return the start knob, and pull it strongly.Never pull the rope to the full. Once the start knob is pulled, never release–your hand immediately. Hold the start knob until it returns to its originalpoint.6) Choke leverWhen the engine starts, open the choke lever.–Open the choke lever progressively while checking the engine operation.–Be sure to open the choke lever to the full in the end.In cold or when the engine is cooled down, never open the choke lever–suddenly. Otherwise, the engine may stop.7) Warm-up operationContinue warm-up operation for 2 to 3 minutes.–POINTS IN OPERATION AND HOW TO STOPHigh speedLow speed(start position)CarburetorPrimer PumpCLOSEOPEN