Makita EBH340R Instruction Manual

Also see for EBH340R: Instruction manual

Contents

Makita EBH340R Instruction Manual Manual pdf 9 page image

9(1)(2)(3)(4)(5) (6)CAUTION: Before performing any work on the brushcutter,always switch off the motor and pull the spark plugconnectors off the spark plug. Beware of hot engineparts and sharp blade edges.Always wear protective gloves!CAUTION: Start the brushcutter only after having assembled itcompletely.1. Joining flexible pipe with engine and pipe case holderInsert on end of a flexible pipe (1) into a clutch housing (2) on anengine until it locks with a slight “click” noise.Insert the other end of the flexible pipe into a pipe case (3)holder of a brushcutter until it locks.Each end of the flexible pipe is interchangeable.Make sure that a square end of a flexible shaft fits into the jointof a drive shaft.CAUTION: If you have difficulty to insert the flexible pipeproperly, the square end of the flexible shaft maynot fit the drive shaft joint. Do not force to push toavoid damage on the flexible shaft end. Repeat thesame procedure again until flexible shaft and pipefit properly.2. Mounting of control cableRemove the air cleaner cover.–Place the control cable (4) in the adjusting bolt (5), and shift the–swivel (6) so that the cable will be put in the swivel groove. At thistime, the round-hole side of the swivel will be oriented toward theinner wire end-metal fitting.Release the swivel, and confirm that the inner wire-end metal–fitting will be placed in the hole.Mount the air cleaner cover.–ASSEMBLY OF ENGINE AND DRIVE SHAFTRound-holeEnd fittingControl cableSwivelInsert