Makita EM3400U Original Instruction Manual

Also see for EM3400L: Original instruction manual Original instruction manual Original instruction manual Instruction manual Instruction manual

Contents

Makita EM3400U Original Instruction Manual Manual pdf 12 page image

12(1) (2)(3)Handling petroleum productsUtmost care is required when handling fuel. Fuel may contain substances similarto solvents. Refuel either in a well ventilated area or outdoors. Do not inhale fuelvapors, avoid any contact of fuel or oil with your skin.Mineral oil products degrease your skin. If your skin comes in contact with thesesubstances repeatedly and for an extended period of time, various skin diseasesmay result. In addition, allergic reactions are known to occur. Eyes can be irritatedby contact with oil, fuel etc.If oil comes into your eyes, immediately wash them with clear water.If your eyes are still irritated, see a doctor immediately.Fuel and oil mixtureThe engine of the brushcutter is a high-efficiency two-stroke engine.It is run with a mixture of fuel and two-stroke engine oil. The engine is designedto use unleaded regular fuel with a min. Octane value of 91 RON. If no such fuelis available, you can use fuel with a higher octane value. This will not affect theengine, but may cause poor operating behavior.A similar situation will arise from the use of leaded fuel. To obtain optimum engineperformance and to protect your health and the environment, only unleaded fuelshould be used!For engine lubrication use a two-stroke engine oil (quality grade: JASO FC or ISOEGD), which is added to the fuel. The engine has been designed to use MAKITAtwo-stroke engine oil at mixture ratio of 50:1 to protect the environment. In addition,a long service life and reliable operation with a minimum emission of exhaustgasses is assured. It is absolutely essential to observe a mixture ratio of 50:1MAKITA 2-stroke engine oil. Otherwise reliable function of the brushcutter cannot beguaranteed.The correct mixture ratio:Mix 50 parts gasoline with 1 part MAKITA 2-stroke engine oil (see table on right).NOTE: For preparing the fuel-oil mixture first mix the entire oil quantity withhalf of the fuel required in an approved can which meets or exceedsall local code standards, then add the remaining fuel. Throughly shakethe mixture before filling it into the brushcutter tank. It is not wise toadd more engine oil than specified to ensure safe operation. This willonly result in a higher production of combustion residues which willpollute the environment and clog the exhaust channel in the cylinder,the spark plugs as well as the muffler. In addition, fuel consumptionwill rise and the performance will be decreased.RefuellingNever perform refuelling operations in a closed, unventilated area.The engine must be switched off!– Thoroughly clean the area around the tank cap, to prevent dirt from getting intothe fuel tank (1).– Unscrew the tank cap (2) and fill the tank with fuel.– Never fill the fuel tank to the very top.– Securely screw on the tank cap.– Wipe the screw plug and tank with an absorbent after refuelling!Allow cloths to dry and discard in a proper container.NOTE: In some countries, the tank cap does not have the strap (3).Storage of FuelFuel cannot be stored for an unlimited period of time.Purchase only the quantity required for a 4 week operating period. Only useapproved fuel storage containers.Observe the Safety Instructions on page 4!50:1+Gasoline(premium unleaded)1,000 cc (1 L)5,000 cc (5 L)10,000 cc (10 L)20 cc100 cc200 ccFUELS/REFUELLING