Makita EM403MP Original Instruction Manual

Also see for EM403MP: Original instruction manual

Contents

10 ENGLISHInstalling the nylon cutting headCAUTION: If the nylon cutting head hitsagainst a stone during operation, stop themotor and check the nylon cutting headimmediately.1. Put the receive washer on the shaft.2. Insert the hex wrench through the hole inthe gear case.3. Screw the nylon cutting head onto the shaft.4. After installing nylon cutting head, removethe hex wrench.142 35► 1. Nylon cutting head 2. Receive washer3. Shaft 4. Hex wrench 5. TightenMounting the attachment pipeMount the attachment pipe to the power unit.1. Turn the lever toward the cuttingattachment.1► 1. Lever2. Align the pin with the arrow mark and insertthe attachment pipe until the release button popsup.123► 1. Release button 2. Arrow mark 3. Pin3. Turn the lever toward the power unit.1► 1. LeverMake sure that the surface of the lever is parallelto the pipe.To remove the pipe, turn the lever toward thecutting attachment and pull the pipe out whilepressing down the release button.Fig.12312► 1. Release button 2. Lever 3. Pipe