Makita HS003G Instruction Manual

Also see for HS003G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

18 ENGLISHNOTE: The wireless activation lamps finish blinkingin green after 20 seconds elapsed. Press the wirelessactivation button on the tool while the wireless acti-vation lamp on the cleaner is blinking. If the wirelessactivation lamp does not blink in green, push the wire-less activation button briefly and hold it down again.NOTE: When performing two or more tool registra-tions for one vacuum cleaner, finish the tool registra-tion one by one.Starting the wireless activationfunctionNOTE: Finish the tool registration for the vacuumcleaner prior to the wireless activation.NOTE: Refer to the instruction manual of the vacuumcleaner, too.After registering a tool to the vacuum cleaner, thevacuum cleaner will automatically runs along with theswitch operation of the tool.1. Install the wireless unit to the tool.2. Connect the hose of the vacuum cleaner with thetool.3. Set the stand-by switch on the vacuum cleaner to"AUTO".1► 1. Stand-by switch4. Push the wireless activation button on the toolbriefly. The wireless activation lamp will blink in blue.12► 1. Wireless activation button 2. Wireless activationlamp5. Pull the switch trigger of the tool. Check if thevacuum cleaner runs while the switch trigger is beingpulled.To stop the wireless activation of the vacuum cleaner,push the wireless activation button on the tool.NOTE: The wireless activation lamp on the tool willstop blinking in blue when there is no operation for2 hours. In this case, set the stand-by switch on thevacuum cleaner to "AUTO" and push the wirelessactivation button on the tool again.NOTE: The vacuum cleaner starts/stops with a delay.There is a time lag when the vacuum cleaner detectsa switch operation of the tool.NOTE: The transmission distance of the wireless unitmay vary depending on the location and surroundingcircumstances.NOTE: When two or more tools are registered to onevacuum cleaner, the vacuum cleaner may start run-ning even if you do not pull the switch trigger becauseanother user is using the wireless activation function.