Makita HS003G Instruction Manual

Also see for HS003G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: HS003GBlade diameter 185 mm - 190 mmMax. Cutting depth at 0° 66.0 mm - 68.5 mmat 45° bevel 45.5 mm - 47.5 mmat 56° bevel 34.0 mm - 35.5 mmNo load speed 6,000 min -1Rated voltage D.C. 36 V - 40 V maxOverall length with BL4025 316 mmwith BL4040 331 mmNet weight 4.1 - 5.3 kg• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications and battery cartridge may differ from country to country.• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-est combinations, according to EPTA-Procedure 01/2014, are shown in the table.Applicable battery cartridge and chargerBattery cartridge BL4020 / BL4025 / BL4040* / BL4050F* / BL4080F** : Recommended batteryCharger DC40RA / DC40RB / DC40RC• Some of the battery cartridges and chargers listed above may not be available depending on your region ofresidence.WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridgesand chargers may cause injury and/or fire.Intended useThe tool is intended for performing lengthways andcrossways straight cuts and miter cuts with angles inwood while in firm contact with the workpiece. Withappropriate Makita genuine saw blades, other materialscan also be sawed.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-2-5:Sound pressure level (LpA) : 93 dB (A)Sound power level (LWA ) : 104 dB (A)Uncertainty (K) : 3 dB (A)NOTE: The declared noise emission value(s) hasbeen measured in accordance with a standard testmethod and may be used for comparing one tool withanother.NOTE: The declared noise emission value(s)may also be used in a preliminary assessment ofexposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which thetool is used especially what kind of workpiece isprocessed.WARNING: Be sure to identify safety mea-sures to protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operatingcycle such as the times when the tool is switchedoff and when it is running idle in addition to thetrigger time).VibrationThe vibration total value (tri-axial vector sum) deter-mined according to EN62841-2-5:Work mode: cutting woodVibration emission (a h,W ) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2Work mode: cutting metalVibration emission (ah,M) : 2.5 m/s2 or lessUncertainty (K) : 1.5 m/s2