19 ENGLISH4. Push the wireless activation button on the toolbriefly. The wireless activation lamp will blink in blue.12► 1. Wireless activation button 2. Wireless activationlamp5. Pull the switch trigger of the tool. Check if thevacuum cleaner runs while the switch trigger is beingpulled.To stop the wireless activation of the vacuum cleaner,push the wireless activation button on the tool.NOTE: The wireless activation lamp on the tool willstop blinking in blue when there is no operation for2 hours. In this case, set the stand-by switch on thevacuum cleaner to "AUTO" and push the wirelessactivation button on the tool again.NOTE: The vacuum cleaner starts/stops with a delay.There is a time lag when the vacuum cleaner detectsa switch operation of the tool.NOTE: The transmission distance of the wireless unitmay vary depending on the location and surroundingcircumstances.NOTE: When two or more tools are registered to onevacuum cleaner, the vacuum cleaner may start run -ning even if you do not pull the switch trigger becauseanother user is using the wireless activation function.Description of the wireless activation lamp status1► 1. Wireless activation lampThe wireless activation lamp shows the status of the wireless activation function. Refer to the table below for themeaning of the lamp status.Status Wireless activation lamp DescriptionColorOn BlinkingDurationStandby Blue 2 hours The wireless activation of the vacuum cleaner is available. Thelamp will automatically turn off when no operation is performedfor 2 hours.Whenthe tool isrunning.The wireless activation of the vacuum cleaner is available and thetool is running.ToolregistrationGreen 20 seconds Ready for the tool registration. Waiting for the registration by thevacuum cleaner.2 seconds The tool registration has been finished. The wireless activationlamp will start blinking in blue.CancellingtoolregistrationRed 20 seconds Ready for the cancellation of the tool registration. Waiting for thecancellation by the vacuum cleaner.2 seconds The cancellation of the tool registration has been finished. Thewireless activation lamp will start blinking in blue.Others Red 3 seconds The power is supplied to the wireless unit and the wireless activa-tion function is starting up.Off - - The wireless activation of the vacuum cleaner is stopped.