Makita JR1000FT Instruction Manual

Also see for JR1000FT: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

5ENGLISHExplanation of general viewSPECIFICATIONSModel JR1000FTLength of stroke ...................................................... 14 mmMax. cutting capacitiesPipe .............................................................. 25.4 mmWood ............................................................... 55 mmStrokes per minute (min-1 ) ................................... 0 - 4,800Overall length............................................................... 345Net weight................................................................ 1.5 kgSafety class ................................................................ /II• Due to our continuing program of research and devel-opment, the specifications herein are subject to changewithout notice.• Note: Specifications may differ from country to country.Intended useThe tool is intended for sawing wood, plastic, metal andbuilding materials with a strong impact. It is suitable forstraight and curved cutting.Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated in accordance with European Standardand can, therefore, also be used from sockets withoutearth wire.SPECIFIC SAFETY RULESGEB008-2DO NOT let comfort or familiarity with product (gainedfrom repeated use) replace strict adherence to reciprosaw safety rules. If you use this tool unsafely or incor-rectly, you can suffer serious personal injury.1. Hold power tool by insulated gripping surfaceswhen performing an operation where the cuttingtool may contact hidden wiring or its own cord.Contact with a “live” wire will make exposed metalparts of the tool “live” and shock the operator.2. Use clamps or another practical way to secure andsupport the workpiece to a stable platform. Holdingthe work by hand or against your body leaves it unsta-ble and may lead to loss of control.3. Always use safety glasses or goggles. Ordinaryeye or sun glasses are NOT safety glasses.4. Avoid cutting nails. Inspect workpiece for anynails and remove them before operation.5. Do not cut oversize workpiece.6. Check for the proper clearance beyond the work-piece before cutting so that the blade will notstrike the floor, workbench, etc.7. Hold the tool firmly.8. Make sure the blade is not contacting the work-piece before the switch is turned on.9. Keep hands away from moving parts.10. Do not leave the tool running. Operate the toolonly when hand-held.11. Always switch off and wait for the blade to cometo a complete stop before removing the blade fromthe workpiece.12. Do not touch the blade or the workpiece immedi-ately after operation; they may be extremely hotand could burn your skin.13. Do not operate the tool at no-load unnecessarily.14. Always use the correct dust mask/respirator forthe material and application you are working with.15. Some material contains chemicals which may betoxic. Take caution to prevent dust inhalation andskin contact. Follow material supplier safety data.SAVE THESE INSTRUCTIONS.WARNING:MISUSE or failure to follow the safety rules stated inthis instruction manual may cause serious personalinjury.1 Clamping screw2 Cover3 Shoe4 Hex wrench5 Shoe6 Switch lever7 Speed adjusting dial8 Lower9 Higher10 Lamp11 Holder cover12 Blade clamp13 Fixed position14 Released position15 Saw blade16 Blade clamp17 Front holding area18 Collar