Makita LS002G Instruction Manual

Also see for LS002G: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

31 ENGLISHIn the case of left bevel cut(a) (b) (c) (d)1 21. Inside corner 2. Outside cornerTable (A)– Moldingpositionin thefigureBevel angle Miter angle52/38°type45° type 52/38°type45° typeForinsidecorner(a) Left33.9°Left 30° Right31.6°Right35.3°(b) Left31.6°Left35.3°Foroutsidecorner(c)(d) Right31.6°Right35.3°Table (B)– Moldingposition inthe figureMoldingedge againstguide fenceFinishedpieceFor insidecorner(a) Ceilingcontact edgeshould beagainst guidefence.Finishedpiece will beon the Leftside of blade.(b) Wall contactedge shouldbe againstguide fence.For outsidecorner(c) Finishedpiece will beon the Rightside of blade.(d) Ceilingcontact edgeshould beagainst guidefence.Example:In the case of cutting 52/38° type crown molding forposition (a) in the above figure:• Tilt and secure bevel angle setting to 33.9° LEFT.• Adjust and secure miter angle setting to 31.6°RIGHT.• Lay crown molding with its broad back (hidden)surface down on the turn base with its CEILINGCONTACT EDGE against the guide fence on thesaw.• The finished piece to be used will always be onthe LEFT side of the circular saw blade after thecut has been made.In the case of right bevel cut(a) (b) (c) (d)1 21. Inside corner 2. Outside cornerTable (A)– Moldingpositionin thefigureBevel angle Miter angle52/38°type45° type 52/38°type45° typeForinsidecorner(a) Right33.9°Right30°Right31.6°Right35.3°(b) Left31.6°Left35.3°Foroutsidecorner(c)(d) Right31.6°Right35.3°Table (B)– Moldingposition inthe figureMoldingedge againstguide fenceFinishedpieceFor insidecorner(a) Wall contactedge shouldbe againstguide fence.Finishedpiece will beon the Rightside of blade.(b) Ceilingcontact edgeshould beagainst guidefence.For outsidecorner(c) Finishedpiece will beon the Leftside of blade.(d) Wall contactedge shouldbe againstguide fence.Example:In the case of cutting 52/38° type crown molding forposition (a) in the above figure:• Tilt and secure bevel angle setting to 33.9° RIGHT.• Adjust and secure miter angle setting to 31.6°RIGHT.• Lay crown molding with its broad back (hidden)surface down on the turn base with its WALLCONTACT EDGE against the guide fence on thesaw.• The finished piece to be used will always be onthe RIGHT side of the circular saw blade after thecut has been made.