Makita LS0714 Instruction Manual
Also see for LS0714: Instruction manualInstruction manualInstruction manualParts BreakdownInstruction manual
                                                                        | |
9NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of light, or it maylower the illumination.Laser beam actionFor model LS0714FL only1005519CAUTION:• Never look into the laser beam. Direct laser beammay injure your eyes.To turn on the laser beam, press the upper position (I) ofthe switch. Press the lower position (O) to turn off.Laser line can be shifted to either the left or right side ofthe saw blade by adjusting the adjusting screw as follows.10055201. Loosen the adjusting screw by turning itcounterclockwise.2. With the adjusting screw loosened, slide theadjusting screw to the right or left as far as it goes.3. Tighten the adjusting screw firmly at the positionwhere it stops sliding.Laser line is factory adjusted so that it is positioned within1 mm (0.04") from the side surface of the blade (cuttingposition).NOTE:• When laser line is dim and almost or entirelyinvisible because of the direct sunlight in the indooror outdoor window-by work, relocate the work areato a place not exposed to the direct sunlight.Aligning the laser lineA B005521Laser line can be shifted to either the left or right side ofthe blade according to the applications of cutting. Referto explanation titled "Laser beam action" regarding itsshifting method.NOTE:• Use wood facing against the guide fence whenaligning the cutting line with the laser line at the sideof guide fence in compound cutting (bevel angle 45degrees and miter angle right 45 degrees).A) When you obtain correct size on the left side ofworkpiece• Shift the laser line to the left of the blade.B) When you obtain correct size on the right side ofworkpiece• Shift the laser line to the right of the blade.Align the cutting line on your workpiece with the laser line.ASSEMBLYWARNING:• Always be sure that the tool is switched off andunplugged before carrying out any work on the tool.Hex wrench storage1 2012596The hex wrench is stored as shown in the figure. Whenusing the hex wrench, pull it out of the wrench holder. Afterusing the hex wrench, return it to the wrench holder.1. Wrench holder2. Hex wrench1. Adjusting screw1. Switch for laser |
Related manuals for Makita LS0714
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
manualsdatabase
Your AI-powered manual search engine