Makita LS0714FL Instruction Manual
Also see for LS0714: Instruction manualInstruction manualParts BreakdownInstruction manualParts Breakdown
                                                                    | |
192. Bevel angle(1) 0° bevel anglePush the carriage toward the guide fence andtighten two clamp screws to secure the car-riage. Lower the handle fully and lock it in thelowered position by pushing in the stopperpin. Loosen the lever at the rear of the tool.Turn the 0° bevel angle adjusting bolt (lowerbolt) on the right side of the arm two or threerevolutions counterclockwise to tilt the bladeto the right.Carefully square the side of the blade with thetop surface of the turn base using the triangu-lar rule, try-square, etc. by turning the 0°bevel angle adjusting bolt clockwise. Thentighten the lever securely.Make sure that the pointer on the arm point to0° on the bevel scale on the arm holder. If itdoes not point to 0°, loosen the screw whichsecures the pointer and adjust the pointer sothat it will point to 0°.(2) 45° bevel angleAdjust the 45° bevel angle only after perform-ing 0° bevel angle adjustment. To adjust left45° bevel angle, loosen the lever and tilt theblade to the left fully. Make sure that thepointer on the arm points to 45° on the bevelscale on the arm holder. If the pointer doesnot point to 45°, turn the 45° bevel angleadjusting bolt (upper bolt) on the right side ofthe arm until the pointer points to 45°.Adjusting the position of laser lineFor model LS0714FL onlyWARNING:• As the tool is plugged when adjusting the positionof laser line, take a full caution especially at switchaction. Pulling the switch trigger accidentally causean accidental start of the tool and personal injury.CAUTION:• Never look into the laser beam directly. Direct laserbeam causes damage to your eyes.• Never apply a blow or impact to the tool. A blow orimpact causes the incorrect position of laser line,damage to the laser beam emitting part or a shortlife of the tool.1. Lever2. Arm holder3. 0 degree bevelangle adjustingbolt4. Arm5. Release button1. Triangular rule2. Saw blade3. Top surface ofturn table1. Bevel scale2. Pointer3. Screw12 34 50039431230018191 2 30039441. Left 45 degreesbevel angleadjusting bolt1. Work piece2. Cutting line3. Holder assem-bly (optionalaccessory)1. Vertical vise2. Holder assem-bly (optionalaccessory)100394512300570112005702 |
Related manuals for Makita LS0714
Makita LS0714F Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
manualsdatabase
Your AI-powered manual search engine