Makita LS1013 Instruction Manual

Also see for LS1013: Instruction manual Instruction manual Parts Breakdown Instruction manual Instruction manual

Contents

20There are crown and cove molding joints which aremade to fit “Inside” 90° corners ((1) and (2) in Fig. A) and“Outside” 90° corners ((3) and (4) in Fig. A).MeasuringMeasure the wall length and adjust workpiece on table tocut wall contact edge to desired length. Always makesure that cut workpiece length at the back of the work-piece is the same as wall length. Adjust cut length forangle of cut. Always use several pieces for test cuts tocheck the saw angles.When cutting crown and cove moldings, set the bevelangle and miter angle as indicated in the table (A) andposition the moldings on the top surface of the saw baseas indicated in the table (B).In the case of left bevel cutExample:In the case of cutting 52/38° type crown molding forposition (1) in Fig. A:• Tilt and secure bevel angle setting to 33.9°LEFT.• Adjust and secure miter angle setting to 31.6°RIGHT.1. Inside corner2. Outside corner1. Inside corner2. Outside corner(1) (2) (3) (4)1 2Fig.A0015562(1)(2)(1)(2)(2)(1)(2)(1)(1)(2)(3)(4)1001557For insidecornerFor outsidecornerMoldingposition in Fig. A(1)(2)(3)(4)52/38˚ typeLeft 33.9˚45˚ typeLeft 30˚52/38˚ typeRight 31.6˚Left 31.6˚Right 31.6˚45˚ typeRight 35.3˚Left 35.3˚Right 35.3˚Bevel angle Miter angleTable (A)For insidecornerFor outsidecornerMoldingposition in Fig. A(1)(2)(3)(4)Molding edge againstguide fenceCeiling contact edge shouldbe against guide fence.Wall contact edge should beagainst guide fence.Ceiling contact edge should beagainst guide fence.Finished pieceFinished piece willbe on the Left sideof blade.Finished piece willbe on the Right sideof blade.Table (B)

/ 36

Related manuals for Makita LS1013

Makita LS1013 Instruction Manual

This manual is suitable for:

LS1013

manualsdatabase

Your AI-powered manual search engine