Makita LS1016 Instruction Manual
Also see for LS1016: Instruction manualInstruction manualInstruction manualInstruction manualInstruction manual
                        | |
18009506CAUTION:• Always secure all moving portions before carryingthe tool.• Stopper pin is for carrying and storage purposesonly and not for any cutting operations.MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.WARNING:• Always be sure that the blade is sharp and cleanfor the best and safest performance.CAUTION:• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.Adjusting the cutting angleThis tool is carefully adjusted and aligned at the factory,but rough handling may have affected the alignment. Ifyour tool is not aligned properly, perform the following:1. Miter anglePush the carriage toward the guide fence andtighten the locking screw clockwise and pull thelock lever toward yourself to secure the carriage.Turn the grip counterclockwise which secures theturn base. Turn the turn base so that the pointerpoints to 0° on the miter scale. Then turn the turnbase slightly clockwise and counterclockwise toseat the turn base in the 0° miter notch. (Leave asit is if the pointer does not point to 0°.) Loosen thehex sockets bolts securing the guide fence usingthe socket wrench.Lower the handle fully and lock it in the loweredposition by pushing in the stopper pin. Square theside of the blade with the face of the guide fenceusing a triangular rule, try-square, etc. Thensecurely tighten the hex socket bolts on the guidefence in the order from the right side.1009509Make sure that the pointer points to 0° on the miterscale. If the pointer does not point to 0°, loosen thescrew which secures the pointer and adjust thepointer so that it will point to 0°.1230095252. Bevel anglePush the latch lever forward fully to release the positivestops.(1) 0° bevel angle123009512Push the carriage toward the guide fence andtighten the locking screw clockwise and pullthe lock lever toward yourself to secure thecarriage. Lower the handle fully and lock it inthe lowered position by pushing in thestopper pin. Loosen the lever at the rear ofthe tool.Turn the hex socket bolt on the right side ofthe arm holder two or three revolutionscounterclockwise to tilt the blade to the right.1. Pointer2. Lever3. Bevel scaleplate1. Screw2. Pointer3. Miter scale1. Triangular rule |
Related manuals for Makita LS1016
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
Makita LS1016 Instruction Manual
manualsdatabase
Your AI-powered manual search engine