Makita LS1040 Instruction Manual

Also see for LS1040: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

10This tool is equipped with the sub-fence. It should bepositioned as shown in the figure.CAUTION:• When performing left bevel cuts, flip the fence overto the left position as shown in the figure.Otherwise, it will contact the blade or a part of thetool, causing possible serious injury to theoperator.1001767Vertical vise123645 7001796The vertical vise can be installed in two positions oneither the left or right side of the guide fence or theholder assembly (optional accessory). Insert the vise rodinto the hole in the guide fence or the holder assemblyand tighten the screw to secure the vise rod.Position the vise arm according to the thickness andshape of the workpiece and secure the vise arm bytightening the screw. If the screw to secure the vise armcontacts the guide fence, install the screw on theopposite side of vise arm. Make sure that no part of thetool contacts the vise when lowering the handle all theway. If some part contacts the vise, re-position the vise.Press the workpiece flat against the guide fence and theturn base. Position the workpiece at the desired cuttingposition and secure it firmly by tightening the vise knob.CAUTION:• The workpiece must be secured firmly against theturn base and guide fence with the vise during alloperations.Horizontal vise (optional accessory)1234001807The horizontal vise can be installed on either the left orright side of the base. When performing 15° or greatermiter cuts, install the horizontal vise on the side oppositethe direction in which the turn base is to be turned. Byturning the vise knob counterclockwise, the screw isreleased and the vise shaft can be moved rapidly in andout. By turning the vise knob clockwise, the screwremains secured. To grip the workpiece, turn the viseknob gently clockwise until the projection reaches itstopmost position, then fasten securely. If the vise knob isforced in or pulled out while being turned clockwise, theprojection may stop at an angle. In this case, turn thevise knob back counterclockwise until the screw isreleased, before turning again gently clockwise.The maximum width of the workpiece which can besecured by the horizontal vise is 130 mm.CAUTION:• Grip the workpiece only when the projection is atthe topmost position. Failure to do so may result ininsufficient securing of the workpiece. This couldcause the workpiece to be thrown, cause damageto the blade or cause the loss of control, which canresult in PERSONAL INJURY.Holders and holder assembly (optionalaccessories)1 2002247The holders and the holder assembly can be installed oneither side as a convenient means of supportingworkpieces horizontally. Install them as shown in thefigure. Then tighten the screws firmly to secure theholders and the holder assembly.1. Holder2. Holderassembly1. Vise knob2. Projection3. Vise shaft4. Base1. Vise arm2. Vise rod3. Guide fence4. Holder5. Holderassembly6. Vise knob7. Screw1. Sub-fence

/ 16

Related manuals for Makita LS1040

Makita LS1040 Instruction Manual

This manual is suitable for:

LS1040 LS1040S

manualsdatabase

Your AI-powered manual search engine