Makita M3601 Instruction Manual

Also see for M3601: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

Makita M3601 Instruction Manual Manual pdf 9 page image

9 ENGLISHStraight guideThe straight guide is effectively used for straight cutswhen chamfering or grooving.► Fig.10To install the straight guide, insert the guide bars intothe holes in the tool base. Adjust the distance betweenthe bit and the straight guide. At the desired distance,tighten the wing bolts to secure the straight guide inplace. When cutting, move the tool with the straightguide flush with the side of the workpiece.► Fig.11: 1. Guide bar 2. Clamp screw 3. StraightguideIf the distance (A) between the side of the workpieceand the cutting position is too wide for the straightguide, or if the side of the workpiece is not straight, thestraight guide cannot be used. In this case, firmly clampa straight board to the workpiece and use it as a guideagainst the trimmer base. Feed the tool in the directionof the arrow.► Fig.12Dust nozzle set (For Europeancountries only)Use the dust nozzle for dust extraction. Install the dustnozzle on the tool base using the thumb screw so thatprotrusion on the dust nozzle fit to the notch in thetool base. Then connect a vacuum cleaner to the dustnozzle.► Fig.13: 1. Dust nozzle 2. Thumb screw► Fig.14MAINTENANCECAUTION: Always be sure that the tool isswitched off and unplugged before attempting toperform inspection or maintenance.NOTICE: Never use gasoline, benzine, thinner,alcohol or the like. Discoloration, deformation orcracks may result.To maintain product SAFETY and RELIABILITY,repairs, any other maintenance or adjustment shouldbe performed by Makita Authorized or Factory ServiceCenters, always using Makita replacement parts.OPTIONALACCESSORIESCAUTION: These accessories or attachmentsare recommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory or attachmentfor its stated purpose.If you need any assistance for more details regard-ing these accessories, ask your local Makita ServiceCenter.• Straight & groove forming bits• Edge forming bits• Laminate trimming bitsNOTE: Some items in the list may be included in thetool package as standard accessories. They maydiffer from country to country.Router bitsStraight bit► Fig.15Unit:mmD A L1 L26 20 50 151/4″8 8 60 256 8 50 181/4″6 6 50 181/4″“U”Grooving bit► Fig.16Unit:mmD A L1 L2 R6 6 50 18 3“V”Grooving bit► Fig.17Unit:mmD A L1 L2 θ1/4″ 20 50 15 90°Drill point flush trimming bit► Fig.18Unit:mmD A L1 L2 L38 8 60 20 356 6 60 18 28