Makita M3601 Instruction Manual

Also see for M3601: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

save these instructions

4 ENGLISHSAVE THESE INSTRUCTIONS.WARNING: DO NOT let comfort or familiaritywith product (gained from repeated use) replacestrict adherence to safety rules for the subjectproduct. MISUSE or failure to follow the safetyrules stated in this instruction manual may causeserious personal injury.SymbolsThe followings show the symbols used for tool.voltsampereshertzalternating currentno load speedClass II Constructionrevolutions or reciprocation per minuteFUNCTIONALDESCRIPTIONCAUTION: Always be sure that the tool isswitched off and unplugged before adjusting orchecking function on the tool.Adjusting the depth of cut1. Place the tool on a flat surface. Loosen the screwsecuring the stopper pole.12Fig.1► 1. Stopper pole 2. Screw2. Loosen the lock lever and lower the tool body untilthe router bit just touches the flat surface. Tighten thelock lever to lock the tool body.12Fig.2► 1. Lock lever 2. Screw3. Lower the stopper pole until it makes contact withthe adjusting hex bolt. Align the depth pointer with the"0" graduation.12345Fig.3► 1. Depth pointer 2. Screw 3. Stopper pole4. Adjusting hex bolt 5. Stopper block4. Raise the stopper pole until the desired depthof cut is obtained. The depth of cut is indicated on thescale (1 mm per graduation) by the depth pointer. Thentighten the screw to secure the stopper pole.5. Your predetermined depth of cut can be obtainedby loosening the lock lever and then lowering the toolbody until the stopper pole makes contact with theadjusting hex bolt.CAUTION: Since excessive cutting may causeoverload of the motor or difficulty in controllingthe tool, the depth of cut should not be more than15 mm (9/16″) at a pass when cutting grooveswith an 8 mm (5/16″) diameter bit.CAUTION: When cutting grooves with a 20mm (13/16″) diameter bit, the depth of cut shouldnot be more than 5 mm (3/16″) at a pass.CAUTION: When you wish to cut groovesmore than 15 mm (9/16″) deep with an 8 mm(5/16″) diameter bit or more than 5 mm (3/16″)deep with a 20 mm (13/16″) diameter bit, makeseveral passes with progressively deeper bitsettings.