2ENGLISH (Original instructions)SPECIFICATIONSModel RP0900Collet chuck capacity 6mm, 1/4", 8 mm and/or 3/8"Plunge capacity 0 - 35 mmNo load speed (min -1) 27,000Overall height 217 mmNet weight 2.7 kgSafety class /II• Due to our continuing program of research and development, the specifications herein are subject to change without notice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003END201-5SymbolsThe following show the symbols used for the equipment.Be sure that you understand their meaning before use.・ Read instruction manual.・ DOUBLE INSULATION・ Only for EU countriesDo not dispose of electric equipmenttogether with household wastematerial!In observance of European Directive2002/96/EC on waste electric andelectronic equipment and itsimplementation in accordance withnational law, electric equipment thathave reached the end of their life mustbe collected separately and returned toan environmentally compatiblerecycling facility. ENE010-1Intended useThe tool is intended for flush trimming and profiling ofwood, plastic and similar materials. ENF002-2Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated and can, therefore, also be usedfrom sockets without earth wire. ENG905-1NoiseThe typical A-weighted noise level determinedaccording to EN60745:Sound pressure level (LpA) : 89 dB(A)Sound power level (LWA) : 100 dB(A)Uncertainty (K) : 3 dB(A)Wear ear protectionENG900-1VibrationThe vibration total value (tri-axial vector sum)determined according to EN60745:Work mode : cutting grooves in MDFVibration emission (ah ) : 4.0 m/s 2Uncertainty (K) : 1.5 m/s 2ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-16For European countries onlyEC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:RouterModel No./ Type: RP0900are of series production and