Makita RP0900 Instruction Manual

Also see for RP0900: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

4Power tool use and care18. Do not force the power tool. Use the correctpower tool for your application. The correctpower tool will do the job better and safer at therate for which it was designed.19. Do not use the power tool if the switch doesnot turn it on and off. Any power tool thatcannot be controlled with the switch is dangerousand must be repaired.20. Disconnect the plug from the power sourceand/or the battery pack from the power toolbefore making any adjustments, changingaccessories, or storing power tools. Suchpreventive safety measures reduce the risk ofstarting the power tool accidentally.21. Store idle power tools out of the reach ofchildren and do not allow persons unfamiliarwith the power tool or these instructions tooperate the power tool. Power tools aredangerous in the hands of untrained users.22. Maintain power tools. Check for misalignmentor binding of moving parts, breakage of partsand any other condition that may affect thepower tool’s operation. If damaged, have thepower tool repaired before use. Many accidentsare caused by poorly maintained power tools.23. Keep cutting tools sharp and clean. Properlymaintained cutting tools with sharp cutting edgesare less likely to bind and are easier to control.24. Use the power tool, accessories and tool bitsetc. in accordance with these instructions,taking into account the working conditionsand the work to be performed. Use of thepower tool for operations different from thoseintended could result in a hazardous situation.Service25. Have your power tool serviced by a qualifiedrepair person using only identicalreplacement parts. This will ensure that thesafety of the power tool is maintained.26. Follow instruction for lubricating andchanging accessories.27. Keep handles dry, clean and free from oil andgrease. GEB018-4ROUTER SAFETY WARNINGS1. Hold power tool by insulated grippingsurfaces, because the cutter may contact itsown cord. Cutting a "live" wire may makeexposed metal parts of the power tool "live" andshock the operator.2. Use clamps or another practical way to secureand support the workpiece to a stableplatform. Holding the work by your hand oragainst the body leaves it unstable and may leadto loss of control.3. Wear hearing protection during extendedperiod of operation.4. Handle the bits very carefully.5. Check the bit carefully for cracks or damagebefore operation. Replace cracked ordamaged bit immediately.6. Avoid cutting nails. Inspect for and remove allnails from the workpiece before operation.7. Hold the tool firmly with both hands.8. Keep hands away from rotating parts.9. Make sure the bit is not contacting theworkpiece before the switch is turned on.10. Before using the tool on an actual workpiece,let it run for a while. Watch for vibration orwobbling that could indicate improperlyinstalled bit.11. Be careful of the bit rotating direction and thefeed direction.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to cometo a complete stop before removing the toolfrom workpiece.14. Do not touch the bit immediately afteroperation; it may be extremely hot and couldburn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They maycause cracks in the tool base.16. Use bits of the correct shank diametersuitable for the speed of the tool.17. Some material contains chemicals which maybe toxic. Take caution to prevent dustinhalation and skin contact. Follow materialsupplier safety data.18. Always use the correct dust mask/respiratorfor the material and application you areworking with.SAVE THESE INSTRUCTIONS.WARNING:DO NOT let comfort or familiarity with product(gained from repeated use) replace strict adherenceto safety rules for the subject product. MISUSE orfailure to follow the safety rules stated in thisinstruction manual may cause serious personalinjury.