Makita RP0900 Instruction Manual

Also see for RP0900: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

6ENGLISH (Original instructions)Explanation of general viewSPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to change withoutnotice.• Specifications may differ from country to country.• Weight according to EPTA-Procedure 01/2003Intended use ENE010-1The tool is intended for flush trimming and profiling ofwood, plastic and similar materials.Power supply ENF002-1The tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, and canonly be operated on single-phase AC supply. They aredouble-insulated in accordance with European Standardand can, therefore, also be used from sockets withoutearth wire.General Power Tool SafetyWarnings GEA010-1WARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings andinstructions for future reference.ROUTER SAFETY WARNINGSGEB018-21. Hold power tools by insulated gripping surfaceswhen performing an operation where the cuttingtool may contact hidden wiring or its own cord.Contact with a “live” wire will make exposed metalparts of the tool “live” and shock the operator.2. Use clamps or another practical way to secure andsupport the workpiece to a stable platform.Holding the work by hand or against your body leavesit unstable and may lead to loss of control.3. Wear hearing protection during extended periodof operation.4. Handle the bits very carefully.5. Check the bit carefully for cracks or damagebefore operation. Replace cracked or damaged bitimmediately.6. Avoid cutting nails. Inspect for and remove allnails from the workpiece before operation.7. Hold the tool firmly with both hands.8. Keep hands away from rotating parts.9. Make sure the bit is not contacting the workpiecebefore the switch is turned on.10. Before using the tool on an actual workpiece, let itrun for a while. Watch for vibration or wobblingthat could indicate improperly installed bit.11. Be careful of the bit rotating direction and the feeddirection.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to come to acomplete stop before removing the tool fromworkpiece.14. Do not touch the bit immediately after operation; itmay be extremely hot and could burn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They may causecracks in the tool base.16. Draw attention to the need to use cutters of thecorrect shank diameter and which are suitable forthe speed of the tool.17. Some material contains chemicals which may betoxic. Take caution to prevent dust inhalation andskin contact. Follow material supplier safety data.18. Always use the correct dust mask/respirator forthe material and application you are working with.1. Stopper pole2. Screw3. Lock lever4. Depth pointer5. Adjusting hex bolt6. Stopper block7. Switch trigger8. Workpiece9. Bit revolving direction10. View from the top of the tool11. Feed direction12. Straight guide13. Guide bar14. Clamp screw15. Base16. Templet guide17. Bit18. Templet19. Distance (X)20. Outside diameter of the templetguide21. Dust nozzle22. Thumb screwModel RP0900Collet chuck capacity 6mm, 1/4”, 8 mm and/or 3/8”Plunge capacity 0 - 35 mmNo load speed (min -1) 27,000Overall height 217 mmNet weight 2.7 kgSafety class /II